![]() ![]() ![]() So, while building your Ender 3 make sure to pay special attention to those kinds of details unless you want to have to take everything apart to solve the problem later on. Not only that, but since the Z Axis were a bit rotated, the power supply ended up being a bit too close to the bed and depending on how I placed the magnetic build surface on it, when the bed moved backwards it would come into contact with the power supply which causes friction, and this is definitely not what you want. In my case, the Z Axis were slightly rotated which meant that the right carriage (the one on the opposite side to the Z-Rod and where the power supply is attached to) couldn’t roll up and down properly and was sagging a bit, which caused a whole set of problems since I couldn’t get the bed leveled because at times it would sag while at others it wouldn’t, and this threw me off. I did run into a couple problems while building it though, since I didn’t pay special attention to having everything squared perfectly (which is something that they don’t tell you in the instructions), and this led to a couple print issues which meant that I had to go back and take the printer apart partially to make sure everything was properly aligned. ![]() Setting everything up (Some Build Process issues) However, it doesn’t come with Gummybears like the Prusa machines do but hey, it’s still a great experience. The instructions are very clear and to the point, with loads of pictures that guide you through the whole process. The printer came extremely well packaged and everything required to put it together was there, in fact, they included a couple additional pieces even when they weren’t needed (such as screws, nuts, etc.) just to make sure that you have enough to build the machine properly.įrom start to finish it must have taken me about an hour to put the Ender 3 together and to be ready to start my first print. Without any further ado, let’s get started! Printer assembly Check out our recommended products section.Ender 3 Power Loss Recovery Works but has its flaws.Types of Build Surfaces/Beds and their pros & cons.Setting everything up (Some Build Process issues). ![]()
0 Comments
Leave a Reply. |